Mouse using 8000hz polling rate not recognized. How to enable?

Mouse with polling rate set to 8000hz in firmware is not recognized in F36 Plasma (installed system and live usb disk). Mouse works in Kubuntu. When set to 1000hz mouse is recognized.

Which software is responsible? How to find out?

Hey welcome to Fedora Community:)!

Well, can u pls share more info about your mouse that you’re using atm aka label?
Thx :slight_smile:



Thank you for the welcome!

I don’t know exactly what you mean with label. I looked up the following information:

$ lsusbd
Bus 005 Device 005: ID 04d8:a3cf Microchip Technology, Inc.
$ usb-devices
T:  Bus=05 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 33 Spd=480 MxCh= 0
D:  Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs=  1
P:  Vendor=04d8 ProdID=a3cf Rev=02.00
S:  SerialNumber=348239793438
C:  #Ifs= 1 Cfg#= 1 Atr=e0 MxPwr=100mA
I:  If#= 0 Alt= 0 #EPs= 1 Cls=03(HID  ) Sub=01 Prot=02 Driver=usbhid
E:  Ad=81(I) Atr=03(Int.) MxPS=   6 Ivl=125us

The mouse is a Zaunkoenig M2K.

Thx for sharing your info.

This should help you:



1 Like

I don’t know what happened, before reading the supplied information the mouse worked this morning. Didn’t reboot, woke from suspend. Mouse was in the same usb port. Thank you nonetheless for the interesting article.

That’s great that now it’s working for u. But if u should face issues again, pls report it here. Don’t hesitate doing this.
It’s not nonethelss reading here :)! We’re happy to help users anytime.