I’m using Silverblue 39. Trying to connect a samba printer using system-config-printer. After putting the SMB printer address I was met with Unable to find the samba-client you were searching for. from gnome-software, despite that samba-client is already pre-installed in Silverblue 39.
In the last step of adding the printer, it shows There was an error during the CUPS operation: 'client error not possible.'
My `rpm-ostree status’ is as followed:
dadstick@fedora:~$ rpm-ostree status
State: idle
Deployments:
fedora:fedora/39/x86_64/silverblue
Version: 39.20231221.0 (2023-12-21T02:17:42Z)
BaseCommit: e0dd82c21ca2da20c698554c4d6fd0a4d439ff85cc360b2d8972f334d9b48dcc
GPGSignature: Valid signature by E8F23996F23218640CB44CBE75CF5AC418B8E74C
Diff: 23 upgraded
LayeredPackages: akmod-nvidia distrobox gnome-tweaks langpacks-en_GB libgda
libgda-sqlite python3-smbc samba supergfxctl
system-config-printer xorg-x11-drv-nvidia
● fedora:fedora/39/x86_64/silverblue
Version: 39.20231220.0 (2023-12-20T00:38:10Z)
BaseCommit: 13c9a27f1c3c46ee5275f66eec1241e79a5aa8b7cb711fae51032c98b74345c5
GPGSignature: Valid signature by E8F23996F23218640CB44CBE75CF5AC418B8E74C
LayeredPackages: akmod-nvidia distrobox gnome-tweaks langpacks-en_GB libgda
libgda-sqlite python3-smbc samba supergfxctl
system-config-printer xorg-x11-drv-nvidia
fedora:fedora/39/x86_64/silverblue
Version: 39.20231220.0 (2023-12-20T00:38:10Z)
BaseCommit: 13c9a27f1c3c46ee5275f66eec1241e79a5aa8b7cb711fae51032c98b74345c5
GPGSignature: Valid signature by E8F23996F23218640CB44CBE75CF5AC418B8E74C
LayeredPackages: akmod-nvidia distrobox gnome-tweaks langpacks-en_GB libgda
libgda-sqlite python3-smbc supergfxctl system-config-printer
xorg-x11-drv-nvidia