High Battery on Laptop 20W ( according to KDE Energy )

My System:

Operating System: Fedora Linux 41
KDE Plasma Version: 6.2.2
KDE Frameworks Version: 6.7.0
Qt Version: 6.7.2
Kernel Version: 6.11.5-300.fc41.x86_64 (64-bit)
Graphics Platform: Wayland
Processors: 16 × AMD Ryzen 7 8845HS w/ Radeon 780M Graphics
Memory: 30.6 GiB of RAM
Graphics Processor: AMD Radeon Graphics / Nvidia RTX 4060 Laptop
Manufacturer: LENOVO
Product Name: 83DH
System Version: Legion Slim 5 16AHP9

What I have done so far

  • Followed RPMFusion Guides and installed proprietary drivers.
  • Installed Nvidia Drivers
  • SecureBoot is signed, Nvidia drivers are signed. They all loaded fine.
  • Envycontrol to switch GPU states ( integrated, hybrid, nvidia ) but switching seems to does nothing. integrated does disconnect the GPU from listing I guess since it breaks nvidia-smi as it should.
  • At battery 77%
    • Hybrid mode - 3h 28min
    • Integrated mode - 2h 58min
    • Nvidia mode - Haven’t tried due to some Wayland+KDE issues

What I am comparing it to.

  • Windows 11 with Nvidia & AMD drivers installed.
  • At battery 75%
    • In Hybrid mode 4h 30min
    • Integrated mode 5h - 6hr
    • Nvidia mode 1h - 2h

Linux, Laptop temperature is always warm to touch where in Windows it’s barely noticeable if I’m not doing anything.

Is this only me? Why can’t I get integrated only mode to last longer than hybrid mode? Is there any tools to actually monitor how much power is CPU actually pulling like hwinfo in Windows? powertop says CPU is not idle but System monitor says 1-5% CPU utilization.

Not fully sure for all apps and setup you using, but I have Dell XPS 15 9510 with Intel iGPU paired to RTX 3050 TI and I never used envy control or other third-party software to control hybrid mode

Just defaults and installed Nvidia drivers with CUDA from rpm-fusion and it just works perfectly

Even I have lost battery capacity 50% now I still get power mode balanced with hybrid mode 3.35 minutes battery life so I think there might be something on your third-party apps that you use to manage and control hybrid

Also I am on KDE and Wayland and it just works no issues at all

Not using anything. Just fresh install. RPM Fusion guides. Envycontrol just handles rtd3 mode settings.