I have a motherboard Asus Z890-P with most recent UEFI fw. It’s running Fedora 44 WS Kernel Linux 7.2.9-201.fc44.x86_64 from a NVME SSD. This boots in approx 35 seconds.
Installed F45 beta WS with Fedora media writer onto an external USB disk Kingston XS2000.
After having booted F45 beta only once (for the first time) a strange USB device (disk) is present in UEFI firmware of the motherboard.
This strange device always called “USB 3-14” makes the “job dracut-initqueue.service” much slower as the job wants to read from “USB 3.14” and time-out has to expire until boot continues.
Only having booted once all Fedora systems (using this job dracut-initqueue.svc) slow down from now on. Boot time is now about 1 minute and 10 seconds on all Fedoras internal on NVME or external.
Only mean/way to get back faster boot back I found is to clear the CMOS and reset the
motherboard to the default value.
This is annoying as all cables have to be disconnected etc.
Problem seems to be a USB device “3.14” present in UEFI fw created from which can’t be read.
chillzone
(Rick The OldFart And **Private Tester**)
3
Along with @barryascott suggestion is it showing in:
efibootmgr
Seems that is the easiest way to remove it.
sudo efibootmgr -b [entry_id] -B
if the system allows it while the device is unplugged.
If the USB drive was zeroed or removed, the entry might remain because some UEFI implementations create “device type entries” or fallback path entries that do not strictly verify the physical presence of the drive at every boot.
I assume that by booting the F45 you don’t mean booting the live system, but the real system as installed on the Kingston device.
If you have fastboot enabled in the UEFI settings, I would suggest to turn it off. Then when booting the UEFI system can then reconfigure what USB devices are connected or not connected.
Your assumption is correct. F45 beta is installed on XS2000 external disk. No live system.
I always try to have “Fast boot” disabled, but default resets this to enabled.
“efibootmgr” only shows 4 or 5 entries. To me this seems to be correct.
The UEFI firmware has “UEFI variables protection mechanisme”. I didn’t know/see this before. May be this prevents/avoids from refreshing EFI non-volatile variables. I switched it to no proctection.
Furthermore this UEFI firmware allows updating UEFI firmware without booting/running the machine. “BIOS FlashBack™ allows you to easily update the BIOS without entering the existing BIOS or operating system.” There is a dedicated USB port for this. USB port with
BIOS FlashBack™ function. It works the board powered but not booted. May be this is the mysterious USB port?
I’ll investigate further and will come back for reporting.